Build TomElliott Kernel

PRE BUILD ENVIRONMENT IS ASSUMED ALREADY INSTALLED ON THE SYSTEM YOU'RE BUILDING NOTE: It is assumed you have root access to the system you're building this on. It also assumes you know your CWD (Current Working Directory).

Build TomElliott Kernel

The below instructions are to build the TomElliott kernel. There is an extra step involved compared to the normal kernel build as there are firmware's built directly into the kernels now.

Download the Kernel

As of the time of this writing kernel 3.13 is the latest. You can use previous, or future kernels as well though.

wget https://www.kernel.org/pub/linux/kernel/v3.x/linux-3.13.tar.xz

Uncompress the kernel

tar -xf linux-3.13.tar.xz

Go into uncompressed linux kernel directory

cd linux-3.13

Download the prerequisite package (THE EXTRA STEP IS HERE)

git clone https://git.kernel.org/cgit/linux/kernel/git/firmware/linux-firmware.git

Prepare the build

make ARCH=i386 menuconfig

Add any choices, or don't but when you exit, it will ask you to save the config, NEEDED.

After you've saved the config.

Build the bzImage

make ARCH=i386 bzImage

This will take a while. Once successful, it will say bzImage created.

Copy the built firmware to your FOG Server's kernel directory.

NOTE: In my example, the FOG Server is the same as my build system. NOTE: Recommend to make a backup of the original /tftpboot/fog/kernel/bzImage before continuing just in case.

cp arch/x86/boot/bzImage /tftpboot/fog/kernel/bzImage