Troubleshoot Capturing

From FOG Project
Revision as of 04:48, 8 July 2016 by Wayne-workman.28155 (talk | contribs) (Created page with "Article under construction. Below, you will find notes / jibberish that I'm collecting to make into an article. ------------------------------------------------------------...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Article under construction. Below, you will find notes / jibberish that I'm collecting to make into an article.



Stuck on /dev/sda

Using Hard Disk: /dev/sda

After this, the capture will not continue to the next step until enter is pressed, then you receive the message:

"Saving Partition Table (GPT)…Invalid Partition DATA!"


Your particular capture issue means the disk has GPT partitions on them where they’re not expected to be.

You will need to put system you’re trying to capture from in an capture-debug state. Once at the prompt, run fixparts and accept the things it asks.

fixparts
/dev/sda
following prompts to delete and then write changes with ‘w’

From there, once fixed, you can type fog and it should begin the capture process without hanging.



Windows 8.0 and above can be affected by the windows dirty bit - often. Please see: Windows Dirty Bit